Nano Ceramic Car Front Window Film 99 Anti Uv Heat Insulation Sun Blocking Solar Window Tint For Car Windshield Rear Side Window 40Inch X 10Feet Roll 80 Vlt

Specification: Material: PET Self-adhesive Structure: 2ply Thickness: 2mil VLT(Visible Light Transmission): 80 VLR(Visible Light Reflection): 12 IR Rej(Infrared Rejection):90 - 95 UV Rej(Ultraviolet Rejection): 99 TSER(Total Solar Energy Rejected): 46 Glare Reduction: 19 SR Haedness: 2H Installation Steps: Step 1. Trim films to the size you want (a little biger than you need) Step 2. Keep Window or Glass clean Step 3. Wet the Window or Glass with much soapy water Step 4. Remove the adhesive film from backing liner ( Please make sure you have removed it before you apply the matte window film to glass) Step 5. Wet the adhesive film with much soapy water Step 6. Set up film on glass Step 7. Squeegee away water and air bubbles with scraper Step 8. Cut off margins and enjoy your works Quick tip: 1. In order to easily remove the protect backing film, simply use 2 pieces of tape to apply to both sides of the corners and pull.Please spray a lot of water before installation. Its better to watch the installation video of window film on YouTube before installation. 99 ANTI-UV - Car window tint film effectively blocks out 99 of UV rays, which can protect your skin and prevent your car seat from aging and fading. And can effectively block the sun heat, creat a comfortable interior environment. Non-metallized auto window tint film ensures the undisrupted use of radio and cell phones in the vehicle. NANO-CERAMIC PRINCIPLE - Adopting nano-ceramic film technology that absorbs sputtering sunlight, absorbs and exchanges heat, so when the vehicle moves, it has a more advantageous heat dissipation effect. Therefore, some customers think that the higher the temperature of the film is the quality of the film itself. In fact, this is the principle of the nano-ceramic film, which absorbs heat first and then dissipates it. NOTE - In order to easily remove the liner protecting the film, simply use 2 pieces of tape to apply to both sides of the corners and pull. And please spray as much soapy water as possible on the glue side and glass before putting it on the window, which will reduce the bubbles. And two people work together will be better. • 2 PLY DESIGN - 2 ply design with a scratch resistant coating, which results in no chances of fading, no bubbling and peeling off even after years of use • SHATTER-PROOF & ANTI GLARE - Strengthen glass, Effectively prevent accidents caused by glass splash. And can effectively block the sun or the car headlamps strong glare light.