MEEFIX Earpiece Speaker Compatible with iPhone 13 Pro Max Snapin Connector No Soldering Face ID Safe 67 Inch Call Audio Replacement

RESTORE CLEAR CALL AUDIO Crackling rattling or muffled sound during phone calls This symptom points to earpiece receiver degradation a common hardware issue in devices over 3 years old MEEFIX replacement targets the failed module directly and restores fullvolume distortionfree call audio SNAPIN CONNECTOR ZERO SOLDERING Unlike earlier generations that require microsoldering this model uses a direct FPC press connector No heat no solder no risk of thermal damage Standard disassembly tools are all you need precise alignment is the only skill required FACE ID FULLY PRESERVED The earpiece on this generation is a standalone component completely separate from the TrueDepth sensor array Swapping it leaves the Face ID flood illuminator and proximity sensors entirely untouched no serialized chip transfer needed ENGINEERED FOR 67 INCH PRECISION Manufactured to factoryspec tolerances for the Pro Max form factor The acoustic chamber rubber gasket and connector position are matched to the original design Offspec parts cause misalignment and silent audio this one seats correctly on first insertion DIAGNOSE BEFORE YOU BUY Confirm the fault before ordering 1 Test a call on speakerphone if speakerphone sounds normal but the earpiece crackles or is silent the earpiece module is the cause 2 Inspect the mesh for debris partial blockage can muffle audio without full failure 3 Rule out software toggle Bluetooth off try a hard reset